The blade has to go in through the mouth
On this page11
A rotary blade is a disc and a disc cannot be tipped in edgewise
It has to pass through the opening flat or at an angle, and the opening is described by the neck finish rather than by the capacity or the outside diameter.
Rotary blades come in three common diameters
Twenty eight millimeters, forty five, and sixty. Forty five is the usual one, twenty eight is for curves and sixty is for cutting through several layers at once.
The first number in a neck finish is its nominal diameter in millimeters
So a 70-400 finish is nominally seventy millimeters across and an 18DIN is nominally eighteen. Reading the field that way turns it into a fit test.
Eleven distinct nominal sizes appear on this shelf
18, 38, 48, 53, 58, 63, 70, 75, 83, 89 and 100 millimeters. The distribution is 55 at seventy, 36 at fifty eight, 27 at eighty nine, 16 at fifty three, 14 at eighteen and 11 at forty eight, with the remaining six sizes carrying twelve rows between them.
A twenty eight millimeter blade clears 157 of the 181 containers
Everything except the fourteen 18DIN rows and the ten rows that record no neck finish at all. Which is almost the whole shelf.
A forty five millimeter blade clears 156
One fewer, because the 38 millimeter row drops out. So the common blade size costs almost nothing in choice, which is the comfortable answer.
A sixty millimeter blade clears 93
Just over half the shelf. The 48, 53 and 58 millimeter finishes all fall away, and those three account for 63 rows between them.
So the large blade is the one that actually constrains the choice
And it constrains it on a field most buyers read as a lid compatibility code rather than as an aperture. The capacity figure gives no warning at all: a 118 mL jar can have a 48 millimeter neck or an 89.
Ten rows cannot be screened this way
They record no neck finish, so they return nothing to the test in either direction. The right reading is that they are unanswered rather than that they fail.
And nominal is not the same as measured
A nominal seventy millimeter finish is a thread specification, not a caliper reading of the opening. The page uses it as a sort order and a rough screen, which is what it can support, and nothing here states an actual aperture for any container.